How to install and assemble display racks

The installation and assembly methods for display stands vary depending on the type. The installation steps for a door-type display stand include: first, taking out all accessories, including one door header, four round tubes, four hooks, one base, and two butterfly screws; then, hanging the hooks on two round tubes and the door header respectively; next, connecting the two round tubes with hooks to the base using butterfly screws and tightening them; then, connecting the remaining two round tubes to the tubes connected to the base; finally, connecting the door header to the uppermost round tube to complete the installation.

 

The installation steps for an X-banner stand are relatively simple: horizontally prop up the iron pipe support frame, insert the two brackets on the upper pole, first hook the upper right corner, pull the graphic with one hand and the support rod with the other, hook the upper left corner, and finally hook the bottom corner.

 

The installation of an A-frame display stand is relatively complex: It requires four rounded corner brackets and two aluminum frame strips. Install the rounded corner brackets at both ends of the two horizontal bars, ensuring they are aligned. After installing the rounded corner brackets and horizontal bars, place the stand on a flat surface with the back facing up. Locate the 4x16 dovetail screws and drive them directly into the strips 2mm from both ends. Then locate the two legs, horizontal supports, and 4x12 self-tapping screws, and use these screws to secure the pre-installed corner brackets to the horizontal supports. After securing the horizontal supports and legs, place the stand on a flat surface with the front facing up. Align the installed horizontal and vertical sides with the leg supports. Open the vertical sides and connect them using the rounded corners already installed on the horizontal sides. After connecting the four open sides, place the stand above the leg supports, aligning the edges of the two vertical sides with the top edges of the two legs. Use 4x16 dovetail screws to directly secure the four corner brackets and vertical sides together. Finally, use 4x12 self-tapping screws to re-secure the two vertical sides to the legs, reinforcing the sturdiness of the frame and legs.

The portable display stand is easy to install; simply pry open the four sides, place the display image, and close it again. When installing the display stand, take care to properly store the accessories, frame, and base to ensure a secure and stable installation.